<<<Link: Full Considerations for Precautions in Home Wiring
Kitchen flues are hard to dismantle
The regret tells: There are a lot of pipes on the top of my kitchen with the corners of the kitchen. I used the cement pressure plate to pack the furniture, and put the exhaust pipe of the hood into it and put a tile on the outside. Results During use, the hood was found to be poorly vented and it was very difficult to replace the exhaust duct.
Afterwards, Zhuge: The flue or fixed pipeline should not be sealed during the decoration. You can wrap it up on the board and scrape white or brush oil on the outside, and leave the access hole for future maintenance.
Decorative background with small painted pitches
The regret tells: the background decoration painting of my family's living room decoration, and the sofa I bought later. The size of the decorative painting was 0.6m×0.6m, and four pieces were hung together. The spacing of each piece was 0.4m and the total length was 3.6m. At the time of hanging, I found it very beautiful, but the 4.2m-long sofa would appear to be too small for the decorative painting. If the distance is bigger, it would be better.
Afterwards, Zhuge: Before hanging the background decorative painting, be sure to determine the length of the living room and the size of the sofa. After comprehensive consideration of these factors, determine the spacing of the decorative painting. If you do the work again, there will be nails left on the wall.
Hanging keel did not consider chandeliers
The regret tells: When I was in the living room ceiling, I didn't think much about it, and I didn't communicate with it. It was completely done by the carpenters themselves. As a result, there was a problem with An Deng. The crystal chandeliers I bought couldn't be overwhelmed. The worker's master said that he did not know about the crystal light, so the keel in the ceiling was very simple and could not bear the weight of the crystal chandeliers.
Geothermal backfill did not level the ground
The regret tells: When my house was renovated in the bedroom, I changed my geothermal heat. I couldn't level the backfill when I was refilling, which caused unevenness on the ground and a large difference in height. Although I couldn't see anything wrong with the naked eye, floor-mounted installers told me that the quality of the floor was really bad, which seriously affected the pavement of the floor and required that the floor be leveled again.
Afterwards, Zhuge: The owner must be present at the time of geothermal backfill. The workers are urged to perform ground leveling on the site. The smoother the floor is, the easier it is to lay the floor. Otherwise, leveling through equal methods of land flow afterwards is not only costly but also complicated.
Entry door size does not leave more than
The regret tells: When installing the second door of the living room into the household, only the thickness of the floor was taken into consideration, and the thickness of the floor mat was not considered. As a result, there was almost no excess after the floor was finished. Originally wanted to put a beautiful floor mat at the entrance, it now seems impossible to achieve.
Afterwards: When installing the door, be sure to fully consider the thickness of the floor, floor tiles, floor mats, etc., leaving more than in advance.
Dome lights are not dual controlled
Regrets about: After six months of renovation, I heard that the ceiling light can be double-controlled, with a switch beside the door and a switch beside the bed. This saves you from lying in bed and turning off the lights in the winter.
Afterwards, Zhuge: Communicating with friends and worker masters during the renovation process, find fitting solutions that suit their home. If you can not do double control lights, you can install the controller on the ceiling light, turn the top light into a remote control, can also achieve dual control effect.
Unreasonable power source
Unfortunately, I said: My home bedroom was not accurately measured when wiring, but roughly visually, to determine the location of the power outlet. As a result, when the computer desk was bought and returned home, it was discovered that the position of the table leg was just blocking the position of the power outlet. There was no way to replace it with a socket, and the line went out.
Afterwards: Before arranging the position of the bedroom power socket, the dimensions of the furniture to be placed should be provided to the electrician as accurately as possible. In addition, under the premise of not affecting the appearance, as many as possible to reserve a few outlets, sooner or later in the future to use.
The bedroom did not play the air conditioning hole in advance
Unfortunately, I said: My home bedroom was not accurately measured when wiring, but roughly visually, to determine the location of the power outlet. As a result, when the computer desk was bought and returned home, it was discovered that the position of the table leg was just blocking the position of the power outlet. There was no way to replace it with a socket, and the line went out.
Afterwards: Before arranging the position of the bedroom power socket, the dimensions of the furniture to be placed should be provided to the electrician as accurately as possible. In addition, under the premise of not affecting the appearance, as many as possible to reserve a few outlets, sooner or later in the future to use.
Experience Talk Outlet Decorate Decorative Painting Living Room Backgrounds Switch Decoration Living Room Flooring Tiles Computer Sofa Cloth Sofa Cloth Door Mat Floor Tiles Bedroom Lamps Kitchen Tiles Small Bedroom
Thermal Resistance,Explosion Proof Thermocouple,Explosion-Proof Thermal Resistor,Reliable And Stable Thermal Resistance
Jiangsu Leitai Automation Instrument Co., Ltd. , https://www.ltybmall.com