â—† Workers perfunctory business owners suffer at home
In home decoration, there are some problems caused by the worker's perfunctory work. For example, in the docking of some walls with doors and windows, especially the docking of two different colors of paint, workers are often the place where most things are done. In fact, the joint processing is very important, once the improper handling will affect the overall decoration effect. When two colors of paint are docked, it is necessary to tape the edges of the first color, and then paint the other color of paint. When the tape is removed after the construction is completed, the seams will be very neat.
The buried pipe must be slotted on the wall and the ground. However, some construction workers are barbaric when slotting, which can easily damage the load-bearing structure of the building and may also damage other nearby pipelines. Therefore, before the construction, the construction team must confirm the direction and position of the pipeline and design the slotting requirements for the wall structure. In addition, it should be noted that the wall of the bearing wall is not allowed to be grooved, and the wall with the insulating layer is not suitable for the groove, and the ground should be grooved to avoid damaging the floor.
â—† Improper substrate treatment seriously affects the quality of decoration
Most of the houses are not well-grounded and need to be re-leveled during home renovations. If the workers are not careful enough, or are deliberately rigged, it is easy to “seek more and more injusticeâ€. However, if a large amount of cement mortar is used in construction, the ground load will be increased and the safety of the building will be hidden. Gong Tingxi said: "Before the ground leveling, you need to do a good job of the ground floor treatment, and then use the cement mortar to level the ground (use a dedicated level to determine the flatness of the entire ground)."
Before applying latex paint and applying tile, you should do a good job of basal surface treatment. If workers cut corners during construction, such as laying tiles directly on the surfaces of lime mortar, lime paste, lime plaster, hemp mortar, and latex paint, it will be difficult to paste firmly and it will take a long time for empty drums to appear. The wall putty is unevenly covered and smooth. After painting latex paint, color differences may occur on the wall. In severe cases, the latex paint may discolor and fall off.
There are also some "little facets" that cannot be ignored when it comes to the quality of decoration acceptance projects. "Small face" refers to those small places where the eyes are not easy to see and people do not pay much attention to, such as the underside of the window board, the inside of the heating cover, the upper edge of the door, etc. These places are most likely to be the most easily cut corners. .
â—†Hide and cut down electricity and water can easily leave hidden dangers
In home decoration, almost all wires are put in PVC pipes and buried in the walls. As the wires are in the PVC pipe, the owner is invisible. If the workers do not operate it seriously, it is very easy to cause the wire to bury the hidden danger in the pipe. If the workers intentionally cut corners, using wires with joints or putting multiple strands of wire in the same PVC pipe would have more serious consequences. Gong Tingxi said: “In this part of the project, it is best to supervise the operation of the workers on site and check the power supply after the installation is completed. It is also necessary to draw a 'pipeline drawing', which is the specific direction of the wire inside the wall, and the floor, ground and neighbors. The size of the wall, the position of the joint in the pipeline, etc. so that it can be repaired in time if a failure occurs."
When installing sockets, switches, and lamps, if the electrician does not wire according to the construction requirements, the owner is likely to cause overheating or even burning of switches, sockets, etc Loss. Construction must be strictly supervised. After all switches and sockets are installed, they must be actually used to check whether there is any fever in each part.
In order to save time, some decoration workers poured a large amount of cement, sand, and concrete into the sewers during construction, causing poor water in the kitchens and bathrooms. Gong Tingxi reminded the decoration owner that, besides strengthening the supervision during construction, after the construction of the waterway is completed, all basins, basins, bathtubs, etc. should be filled with water, and then the water should be drained to see if the water is open and the pipes leak.
Decoration Construction Knowledge Entrance Decoration Paint Lacquer Paint Switch Home Decoration Socket Bathroom Door Bathroom Door Size Bathroom Size Overall Bathroom Bathroom Design Bathroom Tiles
Naips LED Emergency Down Light is specially designed for ceiling recessed emergency lighting. Automatically light at once when buildings main power outage. NON-MAINTAINED type and it can customized the emergency time for different wattage. We can also add the LED emergency driver kits to match different kinds of your LED downlights.
Led Downlight With Emergency Backup,Downlight With Emergency Backup,Emergency Light Downlight,Led Emergency Downlight
Foshan Nai An Lighting Electric Co.,ltd , https://www.emballast.com