Home>Bearing knowledge> Process and method of disassembling the motor (1) |
Process and method of disassembling the motor (1)
Source: China Bearing Network Time: 2018-07-22
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
(1) Remove the belt or disconnect the connecting pin of the oil separator,
(2) Remove the power wiring and grounding wire from the junction box.
(3) Remove the pulley or coupling,
(4) Remove the foot nut and washer,
(5) Remove the front bearing cover,
(6) Remove the front cover,
(7) Demolition of the potential leaf cover,
(8) Destroy the potential leaf,
(9) Remove the rear bearing cover,
(10) Remove the rear end cover,
(11) Pull out the rotor,
(12) Remove the inner cover of the front and rear bearings and the front and rear bearings.
The installation process of the motor is opposite to the disassembly process. For the normal medium and small motors, only the fan cover, the blades, the front bearing cover and the front cover are removed; then the bearing cover and the rear cover together with the front and rear bearings, the bearing inner cover and The rotor is pulled out together.
Recommend to friends comments close window
Bearing related knowledge |
Selection and application of bearings High-quality tapered roller bearing 32024X after inspection of TIMKEN thrust bearing device The steel combination insists on replacing the copper bearing extension bearing life å•¥ is the clearance and how to measure the clearance of the rolling bearing? |
This article links to http://
Please indicate the bearing network http://
Previous: Reasons and Countermeasures for Affecting the Service Life of FAG Bearings Next: The First Suitable Cage for Thrust Ball Bearings
Insulation Pvc Roof Sheet,Heat Insulation Pvc Roof Sheet,Heat Insulation Pvc Roofing Sheet,Pvc Roofing Sheet For Farms
ZHENHAO BUILDING MATERIALS CO.,LTD , https://www.nbpvcroof.com