When the laser cutting machine is working, it is very dangerous if the fault occurs. The novice must be trained by the professional to operate independently. The experts of the laser engraving machine sum up the 13 details of the safe working of the laser cutting machine based on experience, hoping to like it. The laser cutting machine friends are helpful, as follows:
1. Observe the general safe operating procedures of the cutting machine.
13. When working, pay attention to observe the operation of the machine so as to avoid the cutting machine from coming out of the effective range or two accidents.
10. Observe high pressure safety regulations when servicing. When opening the bottle valve, the operator must stand on the side of the bottle. Do not expose the cylinder to sunlight or heat sources. The use and transportation of gas cylinders should comply with the gas cylinder inspection procedures.
8. Keep the laser, bed and surrounding area clean, orderly, and free of oil, and stack the workpiece, sheet, and waste as required.
5. When the equipment is started, the operator must not leave the post or the person to be in charge. If it is necessary to stop, stop or cut off the power switch.
4. Do not process a material before it can be irradiated or heated with a laser to avoid the potential hazard of smoke and vapor. The laser is started in strict accordance with the laser start-up procedure.
2. Operators must be trained to familiarize themselves with the structure, performance, and knowledge of the operating system.
3. Wear protective equipment as required, and wear protective glasses that meet the requirements in the vicinity of the laser beam.
6. Keep the fire extinguisher at your fingertips; turn off the laser or shutter when not working; do not place paper, cloth, or other flammable materials near the unprotected laser beam.
7. When an abnormality is found during processing, it should be stopped immediately, and the fault should be eliminated or reported to the supervisor in time.
9. When using a gas cylinder, avoid welding the welding wire to avoid leakage accidents. Every 40 hours of operation or weekly maintenance, every 1000 hours of operation or every six months of maintenance, in accordance with the regulations and procedures.
11. After starting the machine, the machine should be started in the low speed X and Y directions to check whether there is any abnormality.
12. After entering the new part program, you should try it out and check its operation.
Concerned about surprises
Tag: laser cutting machine laser cylinder laser beam workpiece
Previous: Standard Specification for Screws Next: Painting Class: Coating Film Formation Method for Electrophoretic Coating
DH series homogeneous & emulsification pump is composed of a first-class working chamber. The working chamber is equipped with a group of 3-6-layer stators and 3-6-layer rotors. The tooth discs of each stator and rotor are from coarse to fine, so that the original granular materials of different thickness can smoothly enter the working chamber for layer by layer crushing, dispersion, fine, homogenization and emulsification.There are 5 kinds of products in this series. Developed independently by our company, the application technology is very mature. We have a strong technical team and our users all over the world.
Homogeneous and Emulsification Pumps
NINGBO DURREX PUMPS CO.,LTD , https://www.durrexlobepump.com