1. In order to make Raymond Mill equipment powder machine normal, a “Safety Operation System for Equipment Maintenance†should be established and the operator must have a certain level of technology. The mill's principle performance and operating procedures are well understood to ensure Raymond Mill’s The long-term safe operation of the powder equipment, and at the same time after the mill equipment has been operating for a period of time, it is necessary to carry out necessary inspections, replace the wearing parts in time and pay attention to whether or not grease is added to the grease.
2. When the grinding roller device of Raymond Mill equipment is used for more than 500 hours, the rolling bearings in the roller sleeve must be cleaned when replacing the grinding roller. The damaged parts should be replaced in time. The refueling tool can be used with manual fuel pump and grease gun. .
3, fineness adjustment, according to the size of the material, soft and hard, water content, specific gravity is different, the thickness of the processing is also different, can be adjusted above the analyzer, high speed, high fineness, low speed, fineness. If the fineness is increased, the output will be reduced accordingly. If the requirements are not met, the fan speed should be adjusted, and the user can flexibly control.
4. When parking, stop the feeding first, and the main machine continues to rake, so that the remaining abrasives continue to grind. After about one minute, the main motor and analyzer motor can be turned off to stop the grinding, and then the fan motor is stopped. In order to blow off the remaining powder.
2. When the grinding roller device of Raymond Mill equipment is used for more than 500 hours, the rolling bearings in the roller sleeve must be cleaned when replacing the grinding roller. The damaged parts should be replaced in time. The refueling tool can be used with manual fuel pump and grease gun. .
3, fineness adjustment, according to the size of the material, soft and hard, water content, specific gravity is different, the thickness of the processing is also different, can be adjusted above the analyzer, high speed, high fineness, low speed, fineness. If the fineness is increased, the output will be reduced accordingly. If the requirements are not met, the fan speed should be adjusted, and the user can flexibly control.
4. When parking, stop the feeding first, and the main machine continues to rake, so that the remaining abrasives continue to grind. After about one minute, the main motor and analyzer motor can be turned off to stop the grinding, and then the fan motor is stopped. In order to blow off the remaining powder.
Clay Layer,Clay Layer for Errosion Control,Geosynthetic Clay Liner
Waterproof Material,Geotextile,Geocell Co., Ltd. , http://www.nsgeotextiles.com