Sunlight canopy is very common in our daily life, because whether it is an underground passage or a parking lot, you can see the sun awning canopy everywhere. Next, the decoration house is small, just For everyone to introduce, there is a related knowledge about the sun awning canopy. First of all, let's take a look at how the sun awning canopy is built , and then come to understand what the manufacturers of the sun slabs have.
First, how to build a sun awning canopy
1. The thing we have to do when setting up the canopy is to first check the skeleton, the skeleton must be flat, and there must be no welding burrs or burrs. The skeleton must be thoroughly dried and must not have volatile solvents.
2, then we have to do is to lay butyl waterproof tape on both sides of the skeleton to form a small sink.
3. Place the sun board on the skeleton, and reserve the expansion joint between the board and the board.
4. Next, press the EPDM bead at the interface between the board and the board.
5. After the above steps are completed, it should be fixed with self-drilling screws.
6, we have to remember that the width of the sun plate in the middle of 1.05M at the bottom must be the skeleton, is fixed with a self-drilling screw sleeve button.
7. The solar panel on the wall should not be in direct contact with the wall. Fix it on the wall with angle aluminum, then put the sun panel into it and install it.
8. At the end of the sun panel, first seal the mouth with aluminum tape, and then fix the edge strip or angle aluminum.
9, then we should first check the cutting size and expansion reserve of the sheet is not appropriate, pay attention to leave enough symmetrical expansion gap, the formula is as follows: total expansion gap = expansion coefficient * local installation Larger temperature before and after * plate length.
10. The most important thing left is the hollow board installation project. The part of the middle plate that is clamped by the stencil must contain at least one rib, or the part where the edge of the plate is clamped is 20 mm smaller. Identify the UV-resistant side of the sheet and install it face-out. Never install the UV-proof side inward. This is something we must remember.
Second, the sun plate manufacturers recommend
Foshan Pufeng Building Materials Co., Ltd. is a professional manufacturer of PC series products such as pc sun board, pc endurance board, pc wave tile, U-lock sun board, pc particle board, pc matte board, canopy bracket production and sales for many years. Sex manufacturers. Therefore, his business strength is quite powerful.
How to build a sun awning canopy, Sunshine board manufacturers recommend, Xiaobian stayed here for everyone to introduce here, I hope that after reading the above introduction, the pro will understand how the sun awning canopy is built, then the small series will be very Happy, if you want to know more home improvement information, please continue to pay attention to, the home of the decoration.
More related wonderful reading:
How to build a sun awning canopy? Sunlight canopy notes
Tempered Glass Mirror,Stained Glass,Teleprompter Glass,Colored Aluminium Mirror
SHANDONG TOP LEADER GLASS CO.,LTD , https://www.topleaderglass.com