The solid wood floor has the advantages of good elasticity, warmth and comfort, giving people a sense of return to nature, so it is highly favored by consumers. However, during the use of solid wood flooring, if it is improperly selected and laid, there will be some “common diseases†such as galls, quilting, noise, dirty boards, flower faces, drums, and warping. "Talk about the method of diagnosis and treatment.
Brand shop: Jun licensing solid wood flooring
Insect mites: Because of the biting of insects in the wood, the floor surface can often see piles of powder, which is annoying. The reason is related to the floor selection. In order to prevent worms, the first choice is to purchase floors that have been produced through a steam kiln jet steaming process. Although the price is relatively expensive, all the eggs in the wood have been killed; the second is to carefully select the keel, and there are wormholes or bark. Do not use it.
Quilting: Some floorboards have been spread over a few days and there has been a large gap between the slats. This is mostly related to the high moisture content before the laying of the floor, and it shrinks due to the high temperature or air drying in the room. Note that the moisture content of the floor prior to laying should be in the range of 8% to 13%, and be timely oiled after being laid.
Sound: Because the quality of the floor is not high, people will make a buzzing noise when they walk around, and feel uncomfortable after hearing it. To this end, it should be noted that the keel and the ground, the floor and the keel bond firmly, the number and length of nails appropriate. At the same time, to prevent the keel spacing is too large or the moisture content is too high, otherwise drying and shrinkage after laying will also have a certain impact.
Dirty board: refers to some floors painted, giving people a dirty "gray" feeling, and some even the footprints are clearly visible. To prevent this from happening, it is important to pay attention to the fact that the surface of the board after polishing is kept clean.
Links: User Record: History of the most complete floor installation analysis
Flooring paint
Tempered Glass
Tempered or toughened glass is a type of safety glass processed by controlled thermal to increase its strength compared with normal glass. Tempering puts the outer surfaces into compression and the interior into tension. Such stresses cause the glass, when broken, to crumble into small granular chunks instead of splintering into jagged shards as plate glass (a.k.a. annealed glass) does. The granular chunks are less likely to cause injury.
Tempered glass is often used in applications where using standard glass could pose a potential danger. Tempered glass is stronger than standard glass and does not shatter into large shards when broken. This is important, because it can greatly minimize potential danger in the case of a break. Manufactured through a process of extreme heating and rapid cooling, tempered glass is much harder than normal glass.
In the case that tempered glass does break, it shatters into small pebbles that are void of dangerous, sharp edges. As tempered glass is considered to be much safer than normal glass, you may often here it referred to as safety glass or TOUGHENED GLASS . Tempered glass has a wide variety of uses that you'll find just about everywhere. In fact, the shower doors in your bathroom or the side glass on a motor vehicle are examples of tempered glass.
Annealed glass can be processed into Clear Tempered Glass, Ultra Clear Tempered Glass, printed tempered glass, back painted tempered glass, tempered Laminated Glass, tempered Insulated Glass , tempered Vacuum Insulated Glass and so on, custom made on project request. Can be used for windows, doors, partitions, handrails, balcony, balustrade, fence, table top, decoration, kitchen splashbacks and so on.
tempered glass sheet,curved tempered glass,Clear tempered glas,tempered glass price,tempered glass panels
Shanghai Lead Glass Co.,Ltd , https://www.leadglaze.com