Workshop floor paints are often used in factories, workshops, warehouses, laboratories, wards, operating rooms, workshops, etc. I believe we have also seen them. So how much do you know about the shop floor paint ? Next Xiaobian will introduce it to everyone.
[Workshop Floor Paint Introduction]
The shop floor paint is used for the sake of aesthetics and improving the working environment of the factory floor to achieve environmental protection, reduce dust and wet ground. Epoxy floor, epoxy anti-static floor, corundum wear-resistant floor, and guide Static electricity fire flower wear-resistant floor, self-leveling cement floor, heavy anti-corrosion floor, self-leveling hardener floor construction. With high strength, wear-resistant, beautiful floor, with no seams, solid texture, good chemical resistance, anti-corrosion, dust, easy maintenance, low maintenance costs and so on. Applicable to some places where the sanitary conditions are relatively high, such as the hospital floor, food factory floor, pharmaceutical factory floor, laboratory floor, room floor, etc.
[shop floor paint how to choose]
1, pure functional floor needs
If the factory only requires the ground to be hard-wearing and compressive, it can't afford sanding, dust, durability and certain anti-corrosion ability. Emery grounds can be selected, and concrete seal hardeners.
2, functional and decorative simultaneous demand
If the factory has decorative requirements for the ground, such as the requirement for green ground, or yellow line division. Only epoxy floors can be chosen. According to different requirements on the degree of wear, or on the ground have special requirements, you can make the following choices.
1) Mainly leave people and walk without heavy machinery. This can be selected epoxy flat floor.
2) There are often heavy machinery walking and there are requirements for wear resistance and pressure resistance. In this case, the epoxy mortar floor must be selected.
3) High interior decoration requirements. In this way, you can choose epoxy self-leveling floor or colored sand floor.
4) There is anti-static requirement on the ground. This can choose anti-static floor, there are ordinary type and self-leveling options. Such as garment factories and telecommunications room
5) There are strict requirements on ground anti-corrosion. Epoxy resin floor can be selected.
How to maintain the workshop floor paint
Keep clean and hygienic, avoid impact and scratches: Avoid overweight machines and objects directly hitting the ground; avoid sharp equipment scratching the ground and remove oil and solvent in time: Although the construction floor has good acid and alkali resistance, but also The need for proper care, such as water, acidic or alkaline solvents, engine oil, etc. accumulated on the ground, should be promptly cleaned, it is best not to exceed 24 hours. Timely repair of damage: If the floor paint surface is damaged, there is oil dripping at the damaged place, then the damaged part needs to be repaired in time to prevent the oil from seeping into the ground structure or under the paint layer.
Finally, the color of the paint on the floor of the workshop can be referred to using green, gray and blue colors, and yellow areas can be used in small areas where special warnings are required.
Factory Waterproof Workshop Sliding Door Factory Feng Shui Floor Paint Factory Color Steel Sandwich Board Partition
Self Drilling Screw,Self Drilling Roofing Screw,Self Drilling Screw With Rubber Washer,Hex Washer Self Drilling Screw
Handan Jiankun Hardware Products Co., Ltd / Handan best import and export trade co., Ltd , https://www.jkscrew.com