As the weather warmed, spring came quietly. The kitchen appliances that have gone through a whole winter will usher in the baptism of hot and cold exchange. Do you consider making a comprehensive inspection and maintenance of the electrical appliances in the kitchen according to the changes in the season? Especially the water heater, after entering the spring and summer, the frequency of bathing will increase significantly.
Gas water heater maintenance is in daily life
According to Jiuzheng Building Materials Network, it is often checked whether there is aging, cracking or damage in the gas supply pipeline. Once it is discovered, it must be disposed of in time. At the same time, the water filter of the cold water inlet is cleaned. If the water filter is blocked, the water heater will not work properly.
Always observe the flame condition. If it is found that the flame is abnormal, such as yellow flame, black smoke, etc., stop using it immediately and notify the maintenance personnel for treatment. Entrust qualified professionals to check the heat exchanger and burner for carbon deposits and blockages every six months, and clean them in time, and always observe whether there is water leakage.
Electric water heater scale cleaning is flawed
When the water heater is in normal use, replace the thermostat and heater every three years at the designated service point. When the amount of water in the shower is reduced, it is necessary to clean up the clogged debris in time, and do not replace the parts on the water heater by yourself.
Jiuzheng Building Materials Network reported that the liner should be cleaned once during the season change. The cleaning method is to first cut off the power supply, close the inlet valve, and then open the outlet valve to reverse the plastic drain on the safety valve counterclockwise by 90 degrees. Water and sediment in the net water heater. Then, wash the tap water again, wash it, and then return the drain ear to the original position. Note that it can be energized after filling.
Range hood maintenance is difficult
The most troublesome thing to do at home is the cleaning of the range hood, which is not only greasy, but also difficult to clean. However, if you do not clean the range hood for a long time, it will cause safety hazards such as motor burnout, oil leakage, jitter and excessive friction, short circuit board or control failure.
Mr. Liu, a salesperson of a brand range hood, suggested that as long as the oil hood is dredging as little as possible, if it needs to be cleaned, it should be professionally operated; do not use a damp rag and a slipper to wipe the hood switch if it causes the switch to slow down. Burning the motor will result in the series being wet.
Stainless Steel Fitting,Stainless Pipe Fittings,Ss Pipe Fittings,Stainless Steel Tube Fittings
Inner Mongolia Overseas.Trade co.,LTD , https://www.flangevalvejoint.com