"Universal Bearings" type features and usefulness

Source: China Bearing Network Time: 2014-06-10

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

1. The outer ball bearing consists of a double-sided sealed outer spherical ball bearing and a cast (or steel stamped) bearing seat. The outer spherical ball bearing has the same internal structure as the deep groove ball bearing; however, the inner ring of such a bearing is wider than the outer ring. ring. The outer ring has a spherical outer surface; it is actively aligned with the concave spherical surface of the bearing seat. Usually there is a gap between the inner hole and the shaft of the bearing; the inner ring is fixed by a top wire; a heart, a sleeve or a sleeve. On the axis; and transform with the axis.
2. Thrust spherical roller bearings are used for shafts that accept axial loads. Warp joint load; but warp load shall not exceed 55% of axial load. Compared with other thrust roller bearings; such bearing has lower collision factor; higher speed; and has self-aligning ability. 29000 type bearing roller It is an asymmetrical spherical roller; it can reduce the relative sliding of the stick and the raceway during work; and the roller is long. The diameter is large; the number of rollers is large and the load capacity is large; the oil is usually smooth; the single low speed condition can be smoothed with grease.
3. The angular touch ball bearing has a higher limit speed; it can accept the meridional load and the axial load together; it can also accept the pure axial load; its axial load can be determined by the touch angle; and it increases with the increase of the touch angle. A touch ball bearing can only accept axial loads in one direction; when receiving a meridional load; it causes an additional axial force; it is necessary to apply a reverse load to the echo; thus; the bearings are usually used in pairs.

Recommend to friends comments close window

Bearing related knowledge

Analysis of the appearance of TIMKEN bearing quality discrimination in the misunderstanding of the intake and exhaust control motor bearing bearing fatigue damage
SKF bearing: The effect of the clearance on the number of life factors that should be emphasized in the high-speed rotation of the bearing

This article links to http://
Please indicate the bearing network http://

Previous:The first shaft of the transmission is damaged by the bearing damage. The next section: Analysis of the use of CJ composite bearing bushing

Safety Valve

Safety Valve,Right Angle Safety Valve,Stainless Steel Safety Valve,Pressure Reducing Safety Valve

Jiangsu Hida Marine Valve Co., Ltd , https://www.haidavalve.com